Product Description
The MX202P Microflex Overhead condenser microphone captures Shure quality sound in a compact, adjustable package. The MX202P features a condenser microphone cartridge attached to a flexible, 4" gooseneck with a 30' cable. The plate-mounted preamp offers easy ceiling installation, and when combined with the high sensitivity cartridge's wide frequency response, this microphone provides accurate sound reproduction with a minimum of RF interference or electromagnetic hum. \n \nAlso available with an inline preamp (see product # 270395). \nRequires phantom power.
\n \nFeatures
\n-
\n
- Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum \n
- Balanced, transformerless output for increased immunity to noise over long cable runs \n
-
\n
- Frequency Response \n
- 50 to 17,000 Hz \n
- Output Impedance \n
- 180 ohms actual (EIA rated at 150 ohms) \n
- Sensitivity (At 1,000 Hz, open circuit voltage*) \n
- Cardioid: -35.0 dBV/Pa (17.8 mV) \n
- Supercardioid: -33.5 dBV/Pa (21.1 mV) \n
- All values -12 dB at 0 gain; *1 Pascal = 94 dB SPL \n
- Maximum SPL (1 kHz at 1% THD, 1 k ohm load) \n
- Cardioid: 124.2 dB \n
- Supercardioid: 122.7 dB \n
- All values +6 dB at 0 gain \n
- Equivalent Output Noise (A-weighted) \n
- Cardioid: 28.0 dB SPL \n
- Supercardioid: 26.5 dB SPL \n
- Signal to Noise Ratio (referenced at 94 dB SPL) \n
- Cardioid: 66.0 dB \n
- Supercardioid: 67.5 dB \n
- Dynamic Range at 1 k ohm load \n
- 96.2 dB \n
- 100 dB at 0 gain \n
- Common Mode Rejection \n
- 45.0 dB minimum \n
- Preamplifier Output Clipping Level (1% THD) \n
- -6.0 dBV (0.5 V) \n
- -12 dBV at 0 gain \n
- Polarity \n
- Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector. \n
- Power Requirements \n
- 11 to 52 Vdc phantom, 2.0 mA \n
- Environmental Requirements \n
- Operating Temperature Range: -18 to 57 degrees C (0 to 135 degrees F) \n
- Relative Humidity \n
- 0 to 95% \n
- Cable Length \n
- 9 m (30 ft) \n