Product Description
\n
\n
\n70V Installation AmplifierProfessional Public Address / Installation Amplifier
\n
\n
\n
\n
\n
\n
\nFeatures
\nVersatile input mixing capabilities make the CA1 the solution for small churches, boardrooms and conference room PA applications. Unlike most installation amplifiers in this class, user selectable phantom power is available on three channels to drive condenser microphones, the type most commonly used on podiums or as a lavaliere (tie clip) microphone. \n \nXLR / TRS balanced combi-jack inputs and attenuated RCA unbalanced inputs ensure the CA1 system can interface with any source (CD, Cassette, Satellite Tuner, DVD or video system) your installation may require. \n \nCapable of driving either a 4-ohm speaker load, or four separate 70-volt speaker systems (one 'system' per zone), the CA1 system delivers 180 watts (mono). A pre-amp output is available to feed an auxiliary power amplifier or active subwoofer to enhance the system, or to feed video or audio recording equipment. \nSpecifications
\n| Number of Channels | \n6 | \n
| Inputs - 1/4" / XLR Combi | \n3 | \n
| Inputs - RCA (unbal) | \n2 | \n
| Phantom Power | \nYes | \n
| Headphone Monitor Features | \nYes - main Output | \n
| Record Outputs | \nYes | \n
| Mixer - Signal to Noise Ratio (dB) | \nGreater than 55dB | \n
| Mixer - Freq Resp (Tone and EQ Flat,�2dB) | \n50 - 15kHz | \n
| Amp A - Power Output @ 4 Ohms | \n180 Watts | \n
| Amp A - Power Output -other | \n180 Watts 70-volts | \n
| THD - 1kHz (dB) | \nLess than 1% | \n
| Cooling | \nPassive | \n
| Finish | \nBlack | \n
| Chassis Construction | \nSteel | \n
| Rackmount | \nYes | \n
| Other Features | \nZone Paging / Telephone interface | \n
| Dimensions (DWH, inches) | \n12 x 19 x 6 | \n
| Dimensions (DWH, cm) | \n320 x 480 x 150 | \n
| Weight (lbs/kg) | \n24 / 9 | \n
